RTE data sheet

Self-extinguishing polyolefin heat shrink sleeve with internal adhesive “TTPA41 Series”

Material: Polyolefin
Shrinkage: 4:1 with internal adhesive
Scope: where a high degree of protection is required
Minimum shrinkage temperature: > +110 °C
Min/max operating temperature (external wall only): -55°C to +110°C
Low Flexibility Temperature: No Split (-55°C)
Self-extinguishing (external wall only): according to ASTMD2671B
Colors: Black – other colors on request
Tensile strength: 11 N/mm²according to ASTMD638
Elongation at break: 300% according to ASTMD638
Elongation after heat aging test: 250% (168 hours at 175°C)
Thermal shock: no damage (4 hours at 250°C)
Dielectric strength: ≥ 15 KV/mm
Longitudinal variation: ≤+1% ≤-10% maximum
Water absorption: ≤ 0.5% according to ASTMD570
Specific gravity: 1.45 G/cm³
Mold Resistance: Good
Fluid resistance: good
Copper corrosion: None
Volume resistivity: 10¹⁴ohm.cm

Heat shrink indication

When shrinking the heat-shrinking sleeve, use equipment made for this specific operation such as, for example, guns or hot air tunnels.
Shrink the sleeve starting at one end, the most critical part, and then proceed slowly to the opposite end. This method avoids the formation of air bubbles between the inner wall of the heat shrink sleeve and the object it covers.
In the event that the object to be covered is made of metal or a good heat conductor, it is advisable to preheat the object to avoid “cold areas”, so as to allow a perfect and soft adaptation of the heat-shrinking sleeve.
In order to avoid overheating of the heat shrink sleeve, ensure there is regular heat distribution. Excessive overheating of the material during the shrinking process can cause bubbles, discoloration and in some cases even breakage of the heat-shrinking sleeve.

Delivery Terms

The expected times for order fulfillment are indicated in our Order Confirmation. In urgent cases, by contacting our sales office at the phone number 0373/920659, the shipment of goods can be managed within 24 hours from the date of our order confirmation. For all products not managed in stock, the shipment of goods will be carried out according to the agreements with our sales office.

Delivery

The delivery of goods is ex our warehouse. At the customer's request, our company offers a "Free Domicile with Invoice Charge" service using a shipper contracted with us. For more information regarding delivery, please consult our General Supply Conditions.

Warranty

RTE warrants, during the warranty period, to repair or replace free of charge those parts that, due to poor material quality or workmanship defects, prove to be defective, but only if they have been used in accordance with the provisions in the "Instruction, Use, and Maintenance Manuals", excluding any other damage and liability for direct or indirect damages resulting from improper use.

For more information regarding delivery terms, delivery, and warranty, please consult our General Supply Conditions.